The Aurora bi-metal band saw blade has a titanium nitride coating. A surface hardness of 2300 DPN (micro Vickers) means you have a band saw blade with a surface hardness exceeding tungsten carbide. The lubricity of the titanium nitride coating reduces the heat generation and dramatically improves the abrasion resistance.

Designed exclusively for heat-resistant alloys, nickel-based alloys, titanium alloys, and special cast tensile steels, all with high tensile strength of over 142,000 psi. It features ultra-hard, diamond sharp carbide tipped teeth that resist low thermal conductivity and abrasion that can quickly break down conventional bi-metal type bands.

Designed to reduced heat generated at increased chip load. With reduced tooth stripping and breaking this equates to the lowest possible cost per square inch of metal cutting.

Designed for accurate cuts at a higher cutting rate. This blade features the highest quality sawing grade of carbide.

Designed exclusively for heat-resistant alloys, nickel-based alloys, titanium alloys, and special cast tensile steels, all with high tensile strength of over 142,000 psi. It features ultra-hard, diamond sharp carbide tipped teeth that resist low thermal conductivity and abrasion that can quickly break down conventional bi-metal type bands.

Blade exclusively designed for the light-duty band sawing machines to cover a wide range of cutting applications. No Break-in procedure is necessary.

The Hi-Lo blade features a high and low teeth height design and a 15-degree rake angle. The blade is ideal for cutting hard steels.

With its special alloying technology, Magnum Hi Lo achieves HRC70 tooth hardness. It maintains positive cutting action and outlasts other blades in production cutting of large-diameter, work hardening steels and nickel-base super alloys with tensile strength of up to 164,000 psi.

The MGLB is best suited for cutting structural shapes, tubing and stacks of mild steel pieces. The MGLB allows band saw machines to cut a wide range of material sizes and shapes without requiring a change of blades. Its tough high-speed steel teeth resist chipping, stripping and abrasion. It can also tolerate the occasional improper speeds and feeds that are often used by inexperienced saw operators.

Exclusive use for structural steel. Protector provides long blade life and prevents tooth breakage, eliminating excessive tooth stripping. It can withstand the shock of interrupted cuts, allowing for heavier penetration for faster cutting rates. Protector uses a broaching style set pattern designed to eliminate pinching, which prevents the blade from binding the cut.

Exclusive use for structural steel with M-42 Edge. Which has both strength against tooth chipping and high wear resistance. PROTECTOR EX added to the back face of the tooth tip prevents excessive cutting.

The SGLB was designed to cover a broad range of cutting applications and to provide maximum efficiency in sawing wear-resistant tool steels. The blade's tough M-42 cobalt edge resists heat and abrasion, while the varied pitch tooth form expands the ranges of sizes and shapes that can be sawed successfully without changing blades.